28-6-2011 33 033000=13069F
4. Press 8 8 followed by * to activate the comfort setting. The console responds ‘Thermostat
Setting’
5. Press 8 8 followed by # to set console back to either Economy or Frost setting. The console
responds either ‘Economy Setting’ or ‘Frost Setting’.
Note: The thermostat settings 88* or 88# will only work if the console is Armed Away. Otherwise
you will get an ‘Error’ message.
As soon as you override temperature settings by telephone the only choices are the set-point
on the thermostat, economy or frost. The comfort setting of the individual thermostats which is
set in the options can only be used by use of a timer event. Using the telephone to override
will stop the Heat/Cool timer events from affecting the thermostat operation.
12. Changing Batteries
When used normally the batteries in sensors and remote controls last about a year. The life
span of batteries does depend on how often a sensor is activated.
Console – 4x Rechargeable AA batteries
Power Failure Alarm: When the system is in armed mode, and there may occur a mains power
failure which lasts for at least 15 minutes, the console will dial out and give a message “POWER
FAILURE”
The emergency batteries in the console ensure that even during a power cut the entire system
stays operational for another 12 hours (if there is no alarm). The choice for rechargeable
batteries is because of the longer lifetime, and automatic recharge ability when system is in
running mode.
• If there is an alarm during a power cut, the console will not activate the siren to save
battery power. The telephone dialler works normally.
• If there is a power cut and the emergency batteries are flat, all settings are stored,
because these are programmed into a non-volatile memory (EEPROM). The clock will
need to be reset.
• When you decide to turn off the security system for a longer period (e.g. renovation
work), remove the batteries from the console to avoid them going flat.
• If the emergency batteries are empty or not installed, the BATTERY indicator on will flash.
• If you open up the battery compartment to change the batteries, the word TAMPER will
be visible on the display. After inserting the batteries and closing the compartment,
enter your PIN code (factory settings 0000, see 8.3) to remove the word TAMPER.
Key Chain Remote Control KR18 – 2x CR2016 batteries
• A new KR18 contains fully charged batteries. If the indicator light on the KR18 is not very
bright, the batteries should be replaced.
• Open the remote control (back). Use CR2016, 3V lithium batteries (2x).
• To retain the unique code for the remote control, the batteries need to be replaced
within 30 sec.
• If after replacing the batteries the console does not respond to your remote control,
press the ARM button on your remote control for 4 seconds to reactivate the remote.
Then release the button. You now need to reregister the remote control, using the
procedure described in 3.1.2.
When pressing the ARM button the LED should flash quickly a few times. When the LED lights up
and stays lit, you need to reactivate the KR18.
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales