28-6-2011 34 033000=13069F
Comfort Remote Control SH600 – 4x AAA batteries
• If the indicator light on the SH600 is not very bright, the batteries should be replaced.
• First set the switch on the front of the remote control to SEC. Now open the battery
compartment on the back of the remote control and replace the batteries within 30
seconds.
• If the console does not respond to your remote control after replacing the batteries, press
the PANIC button on your remote control. You now need to reregister the remote control,
using the procedure described in 3.1.2.
Door/Window Sensor DS18 – 2x AAA batteries and Motion Detector MS18 – 2x AA batteries
The console checks the battery status of the DS18 sensor. If the batteries are too weak, the
console will indicate a PROBLEM and the zone number will flash.
• Normally the unique code of the sensor will remain in the memory (if you replace the
batteries within 30 seconds). After replacing the batteries you can check whether the
sensor still has its unique code. You do this by opening the door or window.
DS18: If the sensor has remembered its code, the console display will read ZONE x OPEN (zone
number for X). If nothing happens, the door/window sensor needs to be reregistered (see
4.1.3). Delete zones you do not use anymore (see 9.7) or install the sensor in the same zone as
before.
MS18: If the sensor has remembered its code, the alarm will go off when you walk past the
sensor. If nothing happens, you need to reregister the motion detector (see 4.2.3). Delete the
zone (see 9.7) and reregister the sensor (see 4.2.3).
13. Frequently asked questions
Why does the security system not work?
Check whether you see any text on the console display. If not: check whether the AC adapter
is connected to the mains, whether the electrical wire is plugged into the adapter and
whether the plug is connected to the console.
Check whether you can control the system via the console. If so, check whether the remote
control works by checking whether the control indicator on the remote control flashes when
you press e.g. the ARM button.
Change the batteries if necessary and reinstall the remote control.
What to do if a zone indicator flashes slowly?
One of the sensors or motion detectors has not contacted the base console for a longer time.
Check the batteries in the sensor or motion detector. Erase the zone and reregister the sensor.
Move the sensor so that the signal can reach the console.
If an error is found while setting the alarm, you will hear a repeated two-tone ‘error signal’. If a
sensor indicates there is a problem (e.g. window opened), you can choose not to activate this
sensor.
While the two-tone ‘error signal’ can be heard, you need to press the CLEAR button and reset
the alarm. The zone indicator of the sensor concerned flashes quickly.
What to do if a zone indicator flashes quickly?
You have pressed the CLEAR button to activate the security system while a sensor or motion
detector indicated an error. Solve the problem (i.e. close the window, replace the batteries)
before activating the zone.
What to do if you hear a repetitive one-tone signal when activating the alarm?
This is normal. When activating the alarm there is an exit delay of one minute to leave your
house. You can alter this delay (see 8.1). After one minute the tone will stop and the system will
be switched on.
What if you cannot switch the light on or off using the Lights ON or Lights OFF button on the
remote control?
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales